See Housing Removal on page 72 2. Remove the Control Panel. See Control Panel Removal on page 75 3. Remove one screw securing the Ink Absorber Tray Assembly to the right side of the Printer Mechanism. Remove the Spacer Tray securing the Ink Absorber Tray Assembly at the left side of the Printer Mechanism and remove the Ink Absorber Tray Assembly by pulling it downward. Be sure to reset the Waste Ink Counter, when replacing the Ink Absorber Tray Assembly or Ink Absorber...
Remove the Housing from the printer. Refer to Section 4.2.1 Housing Removal 2. Remove two screws C.B.S. 3x6, F ZN and C.B.P. 3x8, F ZN and detach the Sub Left Panel Housing from the printer mechanism. Detach the stacker at the same time Figure 4-19. Removing the waste drain inkpad unit Figure 4-19. Removing the waste drain inkpad unit 3. Lift the left side of printer and disengage the hook of waste drain ink pad unit, then pull out the waste drain ink pad unit to remove. I Connect the CR...
Pump Mechanism Power Transmission Process The process of conveying the motive power to the paper eject roller by rotating the pinion of PF motor is shown in figure 2-12. This motive power is conveyed to the Gear C through Gear B. In the figure above, although the lever in order to drive Gear C, carriage lock, head cleaner mechanism is shown separately, it is constructed as one unit. Since the engagement of these two parts depends on the tension of the compression spring, if the...